Automatic Agarbatti Making Machine Troubleshooting: 10 Common Problems and How to Fix Them

Not Every Noise Is a Breakdown

A Automatic Agarbatti Making Machine talks to you through sound, vibration and output quality. Most problems start as small, readable signals — a little more vibration, a slightly different tone, a subtle change in the 170 pieces / hour output. This guide translates the ten most common signals into simple actions you can take before calling for service.

The Automatic Agarbatti Making Machine is rated for a production capacity of 170 pieces / hour, which keeps output steady through the working day.

For power, the machine needs 1.3 HP on a 220V single phase (as per model) supply, so a dedicated and stable connection is recommended for clean running.

Remember the golden rule of troubleshooting: fix the cause, never the symptom. Cleaning a clogged feed without checking why it clogged will bring the same problem back tomorrow.

10 Common Problems and Their Fixes

• 1. Unusual noise — check for loose fastenings and apply lubrication at marked points
• 2. Extra vibration — verify the machine is level and the floor bolts are tight
• 3. Output below 170 pieces / hour — check the feed rate and the material quality first
• 4. Inconsistent product quality — reset the standard settings and clean the tooling
• 5. Power trip during start — check the cable, socket and the 1.3 HP load on the line
• 6. Motor heats up — clear dust from vents and check for continuous overloading
• 7. Machine stops suddenly — check the emergency guard and the power connection
• 8. Slow speed or weak action — inspect the belt, coupling and tooling condition
• 9. Smell of burning — switch off, check wiring and call 9540005314 immediately
• 10. Repeated same fault — do not keep restarting; book a proper service visit

The Safe Order of Troubleshooting

Always diagnose in this order: power first (is the 220V single phase (as per model) supply correct for the 1.3 HP rating?), then feed and material, then settings, then mechanical parts. This sequence solves most issues without opening anything. Keep the manual within reach — the exact values for the 170 pieces / hour capacity are printed there.

Never work on the machine while it is connected to power. Switch off, unplug or isolate the supply, and only then inspect or clean. For electrical doubts, stop entirely and call the support line at 9540005314.

Prevention Is the Real Fix

Every problem on the list has a prevention: daily cleaning, regular lubrication, using correct material grades and not overloading the 170 pieces / hour rating. A machine that runs within its design limits — 1.3 HP connected properly, 220V single phase (as per model) stable, feed consistent — simply does not develop these faults.

And when a fault does appear, write it in the logbook even after you fix it. Patterns you can see in writing are problems you can prevent, and the record also helps the MachinesWala service team at 9540005314 diagnose faster if a similar issue comes to them.