Automatic Agarbatti Making Machine Lubrication and Wear Guide: Grease, Oils and Replacement Timing

Friction Is the Silent Killer of Machines

Every moving part of the Automatic Agarbatti Making Machine faces friction, and friction without lubrication is metal destroying metal. The machine’s smooth 170 pieces / hour capacity output relies on bearings and sliding surfaces staying properly greased. This guide maps the parts that need attention, the correct schedule and the wear signs that tell you a replacement is due.

The Automatic Agarbatti Making Machine is rated for a production capacity of 170 pieces / hour, which keeps output steady through the working day.

For power, the machine needs 1.3 HP on a 220V single phase (as per model) supply, so a dedicated and stable connection is recommended for clean running.

Lubrication is also the cheapest part of maintenance — the cost of some grease is nothing against the cost of a seized bearing on a ₹65,000 machine.

The Lubrication Map of the Automatic Agarbatti Making Machine

• Drive bearings — grease at the marked points on the weekly schedule
• Sliding and pivot points — light oil as per the manual
• Tooling and contact surfaces — keep clean and lightly oiled
• Motor bearings — service at the motor’s own schedule
• Gear or chain drive — check oil level and condition monthly
• Fasteners and adjustment screws — oil lightly during cleaning

Use the grades written in the Automatic Agarbatti Making Machine manual. Cheap, wrong-grade grease may feel softer at the counter but will not protect the load these parts carry during 170 pieces / hour production.

Wear Signs You Must Not Ignore

Grease stops wear but wear still happens slowly. Learn the signals: a bearing that sounds rough or runs hot, a belt that looks cracked or glazed, tooling with visible edge wear, and play in moving parts. Any of these signs during a cleaning pass means the part is nearing its replacement point.

Watch the output too. If the Automatic Agarbatti Making Machine output quality drops slightly but consistently even at standard settings, wear is usually building in the tooling or drive. Catching it early keeps the repair small and the 170 pieces / hour capacity intact.

Replacement Timing and Genuine Parts

Replace worn parts in small groups rather than one-by-one, so the machine runs in a matched state. Use genuine components — the Automatic Agarbatti Making Machine depends on precision, and an off-size local part shifts the whole alignment. Order through MachinesWala at 9540005314 with the machine SKU MWAUTOMATI for a perfect match.

Finally, keep the logbook entries of every lubrication and replacement with dates. History makes the next service faster and helps you predict exactly when each component of the Automatic Agarbatti Making Machine will need its next turn. That predictability is the difference between planned maintenance and sudden breakdowns.